Garelick 79715 3.5 GAS RISE COMMANDER SEAT Manuel d'utilisateur télécharger pdf

Installation and Operation Instructions for

Commander Series Seat Hardware

Form 12.489

WARNING

AVOID SERIOUS OR FATAL INJURY DUE TO

ROTATION OF SEAT.

LOCK SWIVEL WHEN SPEED EXCEEDS 5 M.P.H.

OPERATION:

To Slide Seat:

Pull right rear knob out and slide seat to desired location. Release

knob; it will self lock in position.

To Swivel Seat:

45 Degree Auto Lock Mode Pull right knob out. Rotate seat to desired

location. Release knob; it will self-lock in position at 45 degree

increments.

Free Rotation Mode Pull right knob out and rotate the knob 90

degrees clockwise. Release knob. The seat will rotate freely. Rotate

knob 90 degrees counterclockwise to re-engage locking system.

To Adjust Seat Height:

Upward

Note: This adjustment must be made when the seat is unoccupied.

Loosen cam lock by pulling the handle outward. (Cam lock is located

on the outer tube with the handle in front).

Pull the height adjustment lever located on the left side upward.

The seat will rise. Release lever to lock-in desired position. It may be

necessary to assist the seat upward depending on the seat’s location

with respect to its fore and aft position.

Push cam lock handle back to its original position.

Downward

Loosen cam lock by pulling the handle outward. (Cam lock is located

on the outer tube with the handle in front.)

Pull the height adjustment lever located on the left side upward while

remaining seated. When the desired height is achieved, release the

lever. The seat will remain at that height.

Push cam lock handle back to its original position.

Refer to Figure 1A.

LUBRICATION:

For ease of operation, it is recommended that the horizontal slide

action and vertical rise action be periodically lubricated with a light

lubricating oil. Refer to Figure 1A and note three oil ports and the slide

and swivel locks in Figure 2.

MAINTENANCE:

As with all marine hardware installations, it is recommended that any

exposed fasteners be periodically inspected for security. Any loose

screws should be tightened with the appropriate tool.

Note: Clean only with warm soapy water. Never use harsh cleaners or

petroleum products.

FIG. 1

FIG. 2

Write for

a Complete

Catalog

Phone: 651-459-9795

PO Box 8, 644 2nd Street E-mail: [email protected]

St. Paul Park, Minnesota 55071 On the Web: www.garelick.com

5/04

FIG. 1A

Screws “G”

1 2

Résumé du contenu

Page 1 - ROTATION OF SEAT

Installation and Operation Instructions forCommander Series Seat HardwareForm 12.489WARNINGAVOID SERIOUS OR FATAL INJURY DUE TOROTATION OF SEAT.LOCK S

Page 2 - INSTALLATION OF GAS SPRING:

Installation and Operation Instructions – Commander Series Seat HardwareForm 12.489SWIVEL FRICTION ADJUSTMENT:There are six adjusting screws to minimi

Commentaires sur ces manuels

Pas de commentaire

Garelick 79715 3.5 GAS RISE COMMANDER SEAT Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Meubles Garelick 79715 3.5 GAS RISE COMMANDER SEAT. Garelick 79715 3.5 GAS RISE COMMANDER SEAT User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Meubles Garelick 79715 3.5 GAS RISE COMMANDER SEAT