Garelick 10049 LATCH TYPE BOARDING LADDER Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour l'eau Garelick 10049 LATCH TYPE BOARDING LADDER. Garelick 10049 LATCH TYPE BOARDING LADDER User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Installation Instructions for
Ladder Stand-Offs
Form 12.136
Attach stand-offs for the ladder on the lowest step possible so stand-off abuts the hull
of the boat and the ladder hangs over the side in a perpendicular position.
If necessary, stand-offs can be shortened by cutting with a hack saw to desired length.
Use 1/4" bolts and nuts (provided). After stand-offs are attached, place poly tips on
the ends. In some cases it may be easier to slip poly tips on after warming them in hot
water.
If the ladder cannot hang over the side in a perpendicular position when the stand-
offs are mounted to the ladder step as described above, attach the stand-offs on the
ladder uprights at the lowest possible part of the ladder so they abut the hull of the
boat. A 1/4" hole should be drilled in the center of the upright tube and the stand-off
attached (see “A” in fig. 1) at the best position so the ladder hangs perpendicular.
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
4/98
FIG. 1
IMPORTANT
The stand-offs must be attached
through the smaller square holes at
each end of the step.
PARTS LIST
2 – Stand-offs
2 – 1/4"-20 locknuts
2 – 1/4"-20 x 1 1/2" screws
2 – Poly tips
A
Vue de la page 0
1

Résumé du contenu

Page 1 - Ladder Stand-Offs

Installation Instructions forLadder Stand-OffsForm 12.136Attach stand-offs for the ladder on the lowest step possible so stand-off abuts the hullof th

Commentaires sur ces manuels

Pas de commentaire